Is there anything else that I can do from here due to the console now turning on and stating E 79 Someone else completed the RGH so I am trying to get the NAND off of them I can still load Xell but I do not have my original NAND on hand. Until you have determined it's got a good image on it It is not recommended to use update mode on this console again ***** WARNING: due to previous possible errors, console reboot is not being done Loading manifest 17489\$SystemUpdate\system.manifest Manifest not found at 17489\system.manifest Writing FS table to image offset 0xe58000 len 0x4000 (end 0xe5c000).done!įixing up big block controller on small block NAND LBA numbers.done!Ĭalculating ECD bytes and assembling raw image.done! Encrypting and finalizing bootloaders -Īdding smc config to offset 0x00f7c000, len 0x400 Reading bootloader data.success! Bootloader size with xell is 0x000b0000 parsing console info response -ĬPU key : REMOVED KEY FROM THIS POST (weight:0x35 valid ecd: valid)ġBL key : REMOVED KEY FROM THIS POST (good) NAND image size: 0x1080000 Block size: 0x4200 Spare Data: Yes Started, watching network for xbox.success, found xbox beacon at 192.168.1.36Ĭonnected to Trinity with updsvr version 3 (peek version 2) Part of the log file is:ĭata directory set from command line to '17489\' I can get into Xell and I I just found the update log file from the attempted update but did not want to post it all as it has CPU Keys etc and not sure if it should be posted with all that data. The only other things I can add are: I accidentally left my USB HDD in while doing this update - does that matter? Then there was a warning line that told me not to try an update this console again until the issue was found and resolved It failed to send flash data to console successfullyĦ. It found my console on the correct IP Address for the xbox beaconģ.
I was on DashLaunch 3.16 and update serv was enabledĢ. Unfortunately when I went to screen capture I close the cmd prompt so do not have the error but from memory:ġ. I then tried the slim and it failed miserably (unfortunately). I tried my jTag first and it worked flawlessly.
It has worked perfectly fine before on both these consoles. I tried updating to the latest dash using this method ( ) on my jTag and my RGH (Slim 4G Model).
0 kommentar(er)
